Three problems in using hydraulic cylinder

If the hydraulic cylinder can maintain the normal working condition, then can help us to complete a lot of work tasks, and if there are some problems, it will affect the normal performance of its work, so as a user, we need to find out the specific reason in time and deal with it. Below we pass a few problems to analyze the operation of hydraulic cylinder matters needing attention. The first problem, the hydraulic oil in the hydraulic cylinder presents the problem how to do? Trust that every user friend knows, and very clear understanding of the importance of hydraulic oil for the entire system. And in the operation, if the hydraulic oil appears muddy rust color or mixed with a certain amount of water, we must cause attention. In fact, if there is such a problem, we think it is probably due to the simultaneous sealing of the problem. At this time we need to see whether there is oil in the water system, if found seal ring damage should be replaced in time. Second question, in the hydraulic system the main hydraulic cylinder Piston Rod presents the vibration question how to return a responsibility? When encountered in the operation of this problem, we need to carry out a full view, the first to see whether there is a problem of low oil level, such as the need to increase to regular oil level; Secondly, we should check whether there is air leakage in the oil suction system of the main oil pump; thirdly, we should check whether the v-shaped sealing ring of the pushing mechanism is too tight; finally, we should check whether the oil temperature of the hydraulic cylinder is too high. The final question is, what if the temperature of the hydraulic oil used in the hydraulic cylinder is too high? If the operation presents this problem, a time we are very difficult to determine the specific reasons, at this time also need to carry out a series of ability to find specific reasons. Check whether the hydraulic cylinder of the hydraulic pump is in normal load condition; check whether the main relief valve is faulty and often overflow; check whether the hydraulic oil is overheating, sticky and other issues.